News

• How to choose correct bending V size?

  Top select thin plate processing molds, the formula of V=6T fits for plates below 3mm. For plates between 3 to 8mm, V=8T can be used for high requirement customers. For plates more than 8mm thickness, V=12T can be used if the customer does not require high accuracy and radian.

  News December 31, 2021
• Comparison of laser pipe cutting machine and saw blade pipe cutting machine

  This article describes the difference between the laser pipe cutting machine and the saw blade pipe cutting machine, from the perspectives of whether it can cut the bevel and whether the cutting pattern is diverse.

  News December 24, 2021
• Analysis of CNC bending machine usage failure

  This article mainly analyzes the failures of a variety of CNC bending machines, including various situations such as no pressure or no pressure rise in the system.

  News December 16, 2021
• Bending process criterion

  There are six aspects of bending processing criteria, which are preparation before bending, selection of bending die, first piece bending, batch bending, process control, and matters needing attention.

  News December 08, 2021
• How to improve the efficiency of press brake

  Customers who want to improve the positioning efficiency cannot start from the hardware itself, but should consider more reasonable design schemes.

  News December 01, 2021
• How to solve the problem of bending angle difference?

  First of all, users need to understand the cause of the inconsistent bending angle. The inconsistent bending angle is caused by different lowering depth of the molds on both sides.

  News November 30, 2021
• Press Brake Operation Basics

  The bending process is the last and most important process in the forming of most parts (apart from the welding process) and the bending process directly affects the final size and appearance of the product.

  News November 29, 2021
• How to Calculate Press Brake Tonnage

  Usually, the press brake has NC proportional solenoid relief valves which automatically calculate and adjust the pressure according to the bending settings. The proportional solenoid relief valve is actually the combination of an ordinary relief valve and t proportional solenoids or a proportional e

  News November 19, 2021
• CNC Press Brake Controller

  What is the press brake controllerThe press brake controller is a CNC system that is used to control the press brake to process sheet metal.

  News November 10, 2021
• How to Choose the Location of Focal in Laser cutting Process

  Before cutting down any plate, the distance between the laser focal point and the cutting material must be adjusted. Different focal point positions often lead to different degrees of fineness of the cutting material section, different hanging slag at the bottom, or even the inability to cut off the

  News September 23, 2021